Protection of eyes
is required
Anti-noise
Protection
is required
Put on
a respirator
Consider safety
recommendations
Protective
Gloves
are required
Safety precautions under the GOST R 52588-2011 (ЕN 12413)
RECOMMENDATIONS ON SAFE USE OF TOOLS ON
CERAMIC BOND
Transportation and Storage
Instruments must be kept safe from the mechanical attack during transportation and in
storage.
In case of ingress of moisture it is necessary to drain it off and then to check the disbalance
of the wheels. If they are not dry enough than they have increased disbalance and can
break during the work.
Recommendations on Safe Use of Tools
1. The wheels must be examined before their use. There mustn't be any visual
damage. To check if there is a crack on the wheel it is necessary to knock at it with the help
of wooden hammer (150-200 g). If there are no cracks than you'll hear pure sound.
2. Before work it is necessary to examine wheels with the rate of trial start.
3. If wheels have been affected by the additional machining work or penetration it is
necessary to test their mechanical strength before use.
4. During the work an instrument and its attachment must be covered with security
facilities that are applied (protective cover, metallic shield and others).
Don't take off the protective cover during the work.
5. Tools on ceramic bond should not test shock load and be used for the adaptation of
the intermittent area (deseaming of joint weld and so on).
6. There must be gaskets between a wheel and flanges that are used for the fixation of
a wheel. These gaskets cover the pressure plate and equally overhang throughout the full
circumference.
7. The rotation speed of the wheel mustn't exceed the speed indicated on the
wheel.
The RPM can be increased according to the turning of the wheel but the linear
speed mustn't be exceeded.
8. Use safety spectacles, respirator from dust, gloves, and special footwear for your
own protection.